Parts

Support:

+61 8 9479 1444

4. The Polypro 400 suctionpolisher has an“A”-weighted

emission sound pressure level (measured at 1.5

meters) of:

Polypro (Suction Model) - 72dB(A) ± 3dB(A)

Polypro (Non-suction Model) - 55dB(A) ± 3dB(A).

5. Remove brush or padholder when not inuse. Check

for beading or clogging.

6. WARNING Do not use extension cords with the

Polypro 400.

7. Brush and Padholder Use

Part No. FM870 - Bassine Brush 40cm

is intended for general scrubbing of hard floor

surfaces.

Part No. FM871 - Nylon Padholder 40cm

is intended for attaching stripping, scrubbing,

cleaning or buffing pads.

Symbol Definitions

The Regulatory Compliance Mark (RCM) indicates

a device’s compliance with all applicable ACMA

regulatory arrangements.

Operator’s Manual; Operating Instructions

Attention!

4. Transportation and Storage

This appliance and attachments should be packed

in double wall corrugated cardboard boxes with

dimensions of approximately 33cmx 33cmx 54.5cm.

Stack levels of boxes shall not exceed four units in

a vertical position.

RETAIN THESE SAFETY INSTRUCTIONS FOR

FURTHER USE.

Motor Thermostat

IMPORTANT: The motors are equipped with

a thermostat. If for any reason, the polisher

or vacuum motor should over-heat, the

thermostatwillautomaticallyturntheunitoff.

Should this occur, turn off the switch and

unplug the polisher from the electrical outlet

and conduct safety andmaintenance checks.

Allow the polisher to cool for approximately

30 minutes. To re-start, plug into a power

point and switch back on.