Table of Contents Table of Contents
Previous Page  35 / 54 Next Page
Information
Show Menu
Previous Page 35 / 54 Next Page
Page Background

DESCRIPTION

Aqua-Seal STC™OxiTreat HD™ is a fast acting concentrated

acid treatment designed to remove most cement and grout

haze, efflorescence, rust stains, mineral deposits, mortar

residue and smears. OxiTreat HD™will also remove most hard

water stains, lime deposits, soap scum, and ground in dirt and

grime. It will also etch concrete.

USES

Use on ACID RESISTANT natural stone, porcelain, ceramic and

masonry surfaces.

TEST FIRST

The end user must determine the suitability of the product

for their intended use. You should do several test areas in

inconspicuous areas according to the label instructions to

determine surface colour stability and desired results.

PRECAUTIONS

1. Always Test first;

2. Read entire label and product technical bulletin before

using;

3. Wear appropriate skin and eye protection;

4. Concrete and grout to be cured as per the manufacturers

spec;

5. Use when surface temperature is between 4°C and 32°C;

6. Do NOT use on acid sensitive/polished surfaces.

INSTRUCTIONS

1. Sweep, vacuum, or wipe surface;

2. Pre-wet the surface with clean water;

3. Dilute OxiTreat HD™ as follows:

a) LIGHT: Mix 15 parts water to 1 part product;

b) MODERATE: Mix 10 parts water to 1 part product;

c) HEAVY: Mix 5 parts water to 1 part product;

4. Carefully apply the solution to wet surface with a sponge or

mop;

5. Allow to dwell for no longer than 3-5 minutes – DO NOT

ALLOW THE PRODUCT TO DRY ON THE SURFACE;

6. Scrub with a white nylon pad, natural or nylon bristle brush

– always work in small areas;

7. Flush thoroughly with clean water immediately after

scrubbing;

8. Remove the dirty solution with a mop or a wet vac;

9. Rinse thoroughly with clean water as necessary;

10. Repeat the process as necessary always following the

product instructions.

LIMITATIONS

• DO NOT USE ON ACID SENSITIVE/POLISHED SURFACES;

• Do not mix with other cleaners or allow product to come in

contact with any non-recommended surfaces.

• Acids of all kinds may etch, lighten, or change the colour

of cementitious material, metallic glazes and some natural

stones such as marble and limestone.

COVERAGE

Approximately 50–270 square meters per 4 litres. The

coverage will vary depending on density, porosity, texture,

surface absorption, weather, time solution left on surface, the

application method, severity of the problem and dilution used.

HANDLING AND STORAGE:

• Close container tightly after each use.

Store in original container only.

• Store in temperatures between 4°C and 32°C.

FIRST AID

For advice, contact a Poisons Information centre (Phone 131

126) or a doctor. If swallowed, do NOT induce vomiting. If in

eyes, hold eyelids apart and flush the eye continuously with

running water. Continue flushing until advised to stop by

the Poisons Information centre or a Doctor, or for at least 15

minutes. If skin or hair contact occurs, remove contaminated

clothing and flush skin and hair with running water. If irritation

persists, seek medical attention.

SAFETY DIRECTIONS

Wear eye protection when mixing or using.

Wear protective gloves when mixing or using.

POISON: KEEP OUT OF REACH OF CHILDREN

READ SAFETY DIRECTION BEFORE OPENING

CONTAINS

PHOSPHORIC ACID 240 G/L

UN No 1805

HAZCHEM 2 R

CLASS 8

PG III

Transportation Name

PHOSPHORIC ACID SOLUTION

WARRANTY

Aqua-Seal STC™ “The Manufacturer” warrants to the original

purchaser of its products that such products are free from

manufacturing defect and does not warrant or guarantee the

workmanship performed by any person or firm installing its

products. The manufacturer’s obligation under this warranty

is limited solely to the original purchaser and solely shall be

limited to the replacement of the product sold. This warranty

will not extend to any product which has been modified in any

way or which has not been used in accordance with the printed

instructions. The manufacturer makes no other warranties

either expressed or implied. The end user must determine the

suitability of the product for their intended use.

ALWAYS DO A TEST FIRST.

OxiTreat HD

Heavy Duty Acid Treatment

Aqua-Seal STC

Technical Support

Phone

+61 2 9521 4000

or Email

technical@aqua-seal.com.au www.aqua-seal.com.au

Problem Solvers

Stone, Tile & Concrete Solutions

Stone, Tile & Concrete Solutions