Aqua-Seal Chemical MSDS

DESCRIPTION

Aqua-Seal STC™MicroScrub™ is safe yet powerful abrasive

cleaner. Aqua-Seal STC™MicroScrub™ is water based,

biodegradable, No VOC, non toxic and non flammable. Does

not contain any acids. No dwell time required. Will effectively

remove most factory applied waxes and floor finishes, light

grout residue (including epoxy), pencil marks, surface rust,

mineral deposits, ground-in dirt and most sealer residues.

Formulated to safely abrade away surface dirt and grime from

heavily textured, hard to clean surfaces

USES

Use on all natural stone, grout, ceramic, porcelain, terracotta,

Saltillo, quarry tiles, terrazzo, concrete, pavers, masonry. Does

not affect existing penetrating sealers. Aqua-Seal STC™

MicroScrub™ can also be used to boost the performance of

any of cleaners or problem solvers.

TEST FIRST

Due to the nature of different surfaces, you should do several

test areas in inconspicuous areas according to the label

instructions to determine surface colour stability and desired

results. The end user must determine the suitability of the

product for their intended use.

PRECAUTIONS

1. Always Test first;

2. Read entire label and product technical bulletin before using;

3. Wear appropriate skin protection;

4. Use when surface temperature is between 4°C and 32°C.

INSTRUCTIONS

1. Shake well before using;

2. Sweep, vacuum, or wipe surface;

3. Slightly pre wet surface;

4. Apply about ½ - 1 cup of Aqua-Seal STC™MicroScrub™

to the pre wet surface;

5. Scrub the surface with a white nylon pad, scrub brush or

scrub machine;

6. Remove the dirty solution with a wet vac or mop;

7. Rinse thoroughly with clean water;

8. Repeat the process as necessary.

INSTRUCTIONS WHEN USED A BOOSTER

1. Shake well before using;

2. Sweep, vacuum, or wipe surface;

3. Dilute the selected cleaner or problem solver as per that

products instruction label;

4. Carefully apply the solution to wet surface with a sponge or

mop;

5. Allow selected cleaner or problem solver to dwell as per

label instructions – DO NOT ALLOW THE PRODUCT TO

DRY ON THE SURFACE;

6. Apply about ½ - 1 cup of Aqua-Seal STC™MicroScrub™

to the standing solution;

7. Scrub the surface with a white nylon pad, scrub brush or

scrub machine;

8. Remove the dirty solution with a wet vac or mop;

9. Rinse thoroughly with clean water;

10. Repeat the process as necessary.

LIMITATIONS

• Do not allow product to come in contact with any

non-recommended surfaces.

COVERAGE

Approximately 30–300 square meters per 4 litres. The

coverage will vary depending on density, porosity, texture,

surface absorption, weather, time solution left on surface, the

application method, severity of the problem and dilution used.

HANDLING AND STORAGE

• Close container tightly after each use.

• Store in original container only.

• Store in temperatures between 4°C and 32°C.

FIRST AID

For advice, contact a Poisons Information Centre (Phone

131 126) or a doctor. If swallowed, do NOT induce vomiting.

Immediately give at least 3-4 glasses of water. If in eyes, hold

eyelids apart and flush the eye continuously with running

water. Continue flushing until advised to stop by the Poisons

Information centre or a Doctor, or for at least 15 minutes. If

skin or hair contact occurs, remove contaminated clothing and

flush skin and hair with running water. If irritation persists, seek

medical attention. In case of accident or if you feel unwell, seek

medical advice immediately

SAFETY DIRECTIONS

Avoid contact with skin and eyes.

WARRANTY

Aqua-Seal STC™ “The Manufacturer” warrants to the original

purchaser of its products that such products are free from

manufacturing defect and does not warrant or guarantee the

workmanship performed by any person or firm installing its

products. The manufacturer’s obligation under this warranty

is limited solely to the original purchaser and solely shall be

limited to the replacement of the product sold. This warranty

will not extend to any product which has been modified in any

way or which has not been used in accordance with the printed

instructions. The manufacturer makes no other warranties

either expressed or implied. The end user must determine the

suitability of the product for their intended use.

ALWAYS DO A TEST FIRST.

MicroScrub

™

Safe and Powerful Abrasive Cleaner

Aqua-Seal STC

Technical Support

Phone

+61 2 9521 4000

or Email

technical@aqua-seal.com.au www.aqua-seal.com.au

Problem Solvers

Stone, Tile & Concrete Solutions