46 / 65
Issue No 4 – SLATE SEAL SOLVENT
Page 2 of 4
Issue Date : 25/01/2016
Prepared By :
Keith Sadlier
SECTION 4 – FIRST AID MEASURES
First Aid
Swallowed:
If swallowed DO NOT induce vomiting. Wash out mouth with water. Where
vomiting occurs naturally have head below hip level in order to reduce risk of
aspiration Seek immediate medical assistance or contact the Poisons
Information Centre immediately.
Eye:
If in eyes, hold eyelids apart and flush continuously with running water.
Continue flushing until advised by the Poisons Information Centre or a doctor,
or for at least 15 minutes
Skin:
If skin or hair contact occurs, remove contaminated clothing and flush skin
and hair with soap and water. If symptoms develop seek medical attention
Inhaled
Remove victim from source of contamination or move victim to fresh air.
Allow patient to assume most comfortable position. Ensure airways are clear
and have qualified person give oxygen through a face mask if breathing is
difficult. Seek medical attention if effects persist.
Advice to Doctor
Treat symptomatically or consult a Poisons Information Centre
SECTION 5 – FIRE FIGHTING MEASURES
Fire/Explosion Hazard
FLAMMABLE. This product should be stored and used in a well ventilated area away from naked flames, sparks and
other sources of ignition. Prevent build-up of flammable vapours. Hoses should be electrically continuous and
containers bonded to avoid static charge build-up. Keep the container tightly closed
Extinguishing Media
Dry chemical, foam or carbon dioxide. Water spray may be used to keep fire expose containers cool
Special Fire Fighting Procedures
In the event of a fire, water full protective clothing and NIOSH approved self-contained breathing
apparatus with full face operated in the pressure demand or other positive pressure mode
SECTION 6 – ACCIDENTALRELEASE MEASURES
Spills
Ventilate area of leak or spill. Remove all sources of ignition. Wear appropriate personal protective equipment.
Isolate hazard area. Keep unnecessary and unprotected personnel from entering. Contain and recover liquid when
possible. Use non-sparking tools and equipment. Collect liquid in an appropriate container or absorb with an inert
material (eg vermiculite, dry sand, or earth), and place in a chemical waste container. Do not use combustible
materials, such as sawdust. Place used absorbent in suitable sealed containers, follow state or local authority
regulations and guidelines for the disposal of the waste. Clean area with detergent and water – do not allow product
to enter drains sewers or watercourses – inform the local authorities if this occurs.
SECTION 7 – HANDLING AND STORAGE
Handling
:
Open containers cautiously as containers may be under pressure. Use only in a well
ventilated area
.
Avoid skin, eye contact and breathing vapour
Storage
: Store in a well-ventilated place away from ignition sources, foodstuffs and clothing.
Keep containers closed when not in use. Take precautions against static electricity
discharges.
SECTION 8 – EXPOSURE CONTROLS / PERSONAL PROTECTION
Occupational Exposure Limits
:
EXPOSURE
LIMITS:
Name
TWA
STEL
ppm
mg/m
3
ppm
mg/m
3
Xylene
80
350
150
655