Aqua-Seal Chemical MSDS

15 / 54

Product Name: Aqua-Seal Gold+™
Page: 2 of 4
This revision issued: August, 2011
MATERIAL SAFETY DATA SHEET
Issued by: Aqua-Seal STC™ Phone:+61 2 9521-4000(office hours)
Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
Section 3 - Composition/Information on Ingredients
Ingredients CAS No Conc,% TWA (mg/m3) STEL (mg/m3)
Polyfluoroacrylic polymer <15 not set not set
Other non hazardous ingredients various to 100 not set not set
This is a commercial product whose exact ratio of components may vary slightly. Minor quantities of other non hazardous
ingredients are also possible.
The SWA TWA exposure value is the average airborne concentration of a particular substance when calculated over a normal 8 hour working day for a 5 day
working week. The STEL (Short Term Exposure Limit) is an exposure value that may be equalled (but should not be exceeded) for no longer than 15 minutes
and should not be repeated more than 4 times per day. There should be at least 60 minutes between successive exposures at the STEL. The term "peak "is
used when the TWA limit, because of the rapid action of the substance, should never be exceeded, even briefly.
Section 4 - First Aid Measures
General Information:
You should call The Poisons Information Centre if you feel that you may have been poisoned, burned or irritated by this
product. The number is 13 1126 from anywhere in Australia (0800 764 766 in New Zealand) and is available at all times. Have
this MSDS with you when you call.
Inhalation: First aid is not generally required. If in doubt, contact a Poisons Information Centre or a doctor.
Skin Contact: Irritation is unlikely. However, if irritation does occur, flush with lukewarm, gently flowing water for 5 minutes
or until chemical is removed.
Eye Contact: No effects expected. If irritation does occur, flush contaminated eye(s) with lukewarm, gently flowing water for
5 minutes or until the product is removed. Obtain medical advice if irritation becomes painful or lasts more than a few
minutes. Take special care if exposed person is wearing contact lenses.
Ingestion: If product is swallowed or gets in mouth, do NOT induce vomiting; wash mouth with water and give some water
to drink. If symptoms develop, or if in doubt contact a Poisons Information Centre or a doctor.
Section 5 - Fire Fighting Measures
Fire and Explosion Hazards: The major hazard in fires is usually inhalation of heated and toxic or oxygen deficient (or
both), fire gases. There is no risk of an explosion from this product under normal circumstances if it is involved in a fire.
Only small quantities of decomposition products are expected from this product at temperatures normally achieved in a fire.
This will only occur after heating to dryness.
Fire decomposition products from this product are likely to be irritating if inhaled.
Extinguishing Media : Not Combustible. Use extinguishing media suited to burning materials.
Fire Fighting: If a significant quantity of this product is involved in a fire, call the fire brigade.
Flash point : Does not burn.
Upper Flammability Limit: Does not burn.
Lower Flammability Limit: Does not burn.
Autoignition temperature: Not applicable - does not burn.
Flammability Class: Does not burn.
Section 6 - Accidental Release Measures
Accidental release : Minor spills do not normally need any special cleanup measures. In the event of a major spill, prevent
spillage from entering drains or water courses. As a minimum, wear overalls, goggles and gloves. Suitable materials for
protective clothing include rubber, PVC. Eye/face protective equipment should comprise as a minimum, protective goggles. If
there is a significant chance that vapours or mists are likely to build up in the cleanup area, we recommend that you use a
respirator. Usually, no respirator is necessary when using this product. However, if you have any doubts consult the Australian
Standard mentioned below (section 8).
Stop leak if safe to do so, and contain spill. Absorb onto sand, vermiculite or other suitable absorbent material. If spill is too
large or if absorbent material is not available, try to create a dike to stop material spreading or going into drains or waterways.
Sweep up and shovel or collect recoverable product into labelled containers for recycling or salvage, and dispose of
promptly. Recycle containers wherever possible after careful cleaning. After spills, wash area preventing runoff from entering
drains. If a significant quantity of material enters drains, advise emergency services. This material may be suitable for
approved landfill. Ensure legality of disposal by consulting regulations prior to disposal. Thoroughly launder protective
clothing before storage or re-use. Advise laundry of nature of contamination when sending contaminated clothing to
laundry.