Parts

Operate Right

How to vacuum easier and faster with no back strain.

1. Fittheappropriatefloortoolorswapinsertbyslidingouttheendpanelsonthefloortool,fittinginsertand

then sliding end panels back into position (Refer to diagram below).

2. Stand upright, with the bent hand piece section parallel to the floor.

3. Hold the bent hand piece with one hand at a comfortable arm’s length. Use your free hand to hold

the hose to help guide the vacuum as you work.

4. Move forward and away from the power point.

5. Use easy underarm swinging motion when detail cleaning and short dabs when spot cleaning, always

standing upright.

6. Once the end of the power cord has been reached andwork completed, return to the power point along

the cord line and disconnect the power cord from the power point.

7. If work is not completed move to the next area, connect power cord to the nearest power point and

repeat steps 1 through 6.

8. If work is completed disconnect power cord from power point then wind from the canister towards

the end of the power cord to reduce likelihood of cable twists. In the process check for nicks, cuts,

fractures, and knots.

Push end panels of floor

tool outwards to unlock.

Fit appropriate insert into

floor tool.

Push end panels of floor

tool inwards to lock.

How To Swap A Floor Tool Insert

NOTE: Above applies to Hydropro 36 and Hydropro 76 floor tools only.